Transform any guitar rig into a rig of doom!

Pocket-sized reproduction of the “early” EP-3 preamp.

Up to 20dB sparkling, dynamic boost on tap.

22V shunt-regulated internal power supply---BYO 9V supply.

Features: Internal gain pot, internal bypass type switch

Max Delay Time: ~700ms

True Bypass: Yes (switchable to trails mode)

- RATE: Controls the speed of the trem. There are exceptions based on your program, take a look at the matrix below to see them.

- MIX: Controls the wet/dry mix. Turn knob clockwise to hear more effect and counter-clockwise to hear less.

One Knob Overdrive

Control: Overdrive

Provides amp like breakup independent of volume setting

One knob Fuzz

Control: Fuzz

Silicon Fuzz circuit

One Knob Distorsion

Control: Distorsion

Delivers powerful crunch sounds even at low volumes

Low-gain OD / VariOboost

Combines an extremely expressive high-headroom drive engine with a powerful and flexible tone control

Eight-stage phaser with eight selectable phase control parameters

Features a robust LFO engine with classics like sine and square sharing the same control with reverse sawtooth and two independently controlled and intermodulating sine waves

Power Usage: 200mA

Max Delay Time: 800ms

Expression: 1/4" TRS expression input

- MIX: Adjusts the amount of drysignal present in the output, from 100 percent dry to 100 percent wet.

- SHIMMER: Mixes the amount of shimmer present in the room reverb.

- The Cloak runs from 9 to 18 volts.

Controls: Treble, Middle, Bass, Master & Pre-Amp

Power consumption: 5 mA

EQ: tilt style EQ with the center frequency at 900Hz.

Mids: ±10dB active mids boost or cut at 900Hz.

Blend: blends between clean and fuzz sounds, from 100% dry to 100% wet.

Katzenkönig. It's a real word. look it up.

We combined the best elements of a Tone Bender MkII fuzz with a Rat distortion to create something that sings like a fuzz but is tight like a distortion. It loves humbuckers and single coils. It loves your cranked amp and your super-clean amp.

True Bypass switching

5mA power draw at 9vDC, 10mA power draw at 18vDC

Input impedance: 1m