Neumann - Accessories

SG 21 - tripod clamp for small microphone

The SG 21 tripod joint has a plastic clamp for holding small microphones. It has a 5/8"-27 threaded connection, with adapter for 1/2" and 3/8" tripods.

Tripod joint for TLM102, TLM193 and M147

For U87

Made of metal, the threaded connection has 5/8"-27 gears, with adapter for 1/2" and 3/8" tripods.

SG 105 - tripod clamp

Plastic quick-release clamp for KMS vocal microphones. The clamp is swiveling and has a 5/8"-27 threaded connection, with adapter for 1/2" and 3/8" tripods.

On the microphone side it has a 3/8" male thread, on the stand side a 5/8"-27 female thread, plus a thread adapter to connect to 1/2"- and 3/8" stands.

The sound diffraction sphere is placed on the pressure receivers KM 130, KM 131 (A/D), KM 183 (A/D).

The frequency range between 2 kHz and 10 kHz for sound from the front half-space is increased by a maximum of 2.5 dB, while sound components from the rear half-space from approx. 5 kHz are reduced by a maximum of 2.5 dB. IndoorØ 22mm.

The extended length of the KVG 130 nx is approximately 300 mm.

Any KVG ... capsule extension allows to use the KK 1... capsules separated from the output stage without the need for additional cables. At the capsule end, the swivel can be set through ± 110°.

The extended length of the KVG 160 nx is approximately 600 mm.

Any KVG ... capsule extension allows to use the KK 1... capsules separated from the output stage without the need for additional cables. At the capsule end, the swivel can be set through ± 110°.

The extended length of the KVG 1120 nx is approximately 1200 mm

Any KVG ... capsule extension allows to use the KK 1... capsules separated from the output stage without the need for additional cables. At the capsule end, the swivel can be set through ± 110°.

Tripod joint for detached microphone capsules 3/8"

Swivel joint

The swivel joint is inserted between capsule KK 1... and output stage KM D. The capsule can be adjusted by ± 110° can be pivoted and aligned. With an elastic suspension and table flange, mechanically decoupled under-table installation is possible

Mount to attach a KVF.. capsule extensions of the KM 100 system onto a tripod. Especially suited for holding long KVF.. It has a 5/8"-27 thread, plus a thread adapter to connect to 1/2"- and 3/8" stands.